Ionization filter | light mineralization & activated carbon filter cartridge with H2 enrichment - 1
    Ionization filter | light mineralization & activated carbon filter cartridge with H2 enrichment - 2
      Ionization filter | light mineralization & activated carbon filter cartridge with H2 enrichment - 1
      Ionization filter | light mineralization & activated carbon filter cartridge with H2 enrichment - 2

    Ionization filter | light mineralization & activated carbon filter cartridge with H2 enrichment

    €67.00

    For use as a stand-alone water filter for tap water,
    or after a reverse osmosis system or water filter

    Quantity
    Out-of-Stock

    Rating:
    (0)
     

    Sicherheitsrichtlinien

     

    Lieferbedingungen

     

    Rückgabebedingungen

    Guarantee safe & secure checkout

    • For use as a stand-alone water filter for tap water,
      or after a reverse osmosis system or water filter
    • Water filtration with activated carbon granules & functional ceramic beads
    • Mineralization with sintered bioceramic beads such as magnesium, calcium, tourmaline, far infrared, PI-Power and others,
    • thereby increasing the pH value by approx. 1 to 1.5 pH
    • Enrichment with H2 gas: values up to 1 ppm H2 content possible Reduction of
    • the redox value by -300 to -600 mV into the antioxidant range
    • Useful life for 6 months after first contact with water, the longer the useful life, the lower the pH values & H2 content achieved
    • Recommended max.
    • Flow rate: 1 liter/minute
    • Empty weight: 0.6 kg; total weight when filled with water, 1.1 kg
    • Observe flow direction! Ideally mount vertically with inlet at the top

    Two variants to choose from: 1. spin-on filter only without connections
    2. pre-assembled with all connections (2x angle connectors, 1x shut-off valve, wall brackets, screws and plugs)

    40001
      Residues from boiling filtered water. How can this be?

      Impurities in the water before filtering: If the water already contained impurities that were not completely removed by the activated charcoal filter, these impurities may have been concentrated during the boiling process, resulting in residues.

      Overloading the filter: If the activated charcoal filter is overloaded, it may not be able to remove all impurities effectively. This could result in certain impurities, such as limescale, remaining in the water in higher concentrations and building up during cooking.

      Insufficient filter maintenance: Activated charcoal filters must be regularly maintained and replaced to maintain their effectiveness. If the filter has not been properly maintained, its performance may decrease over time, resulting in insufficient removal of impurities.

      Boiling process: In some cases, residues can be created by the boiling process itself, especially if the water has been heavily evaporated and mineral residues remain.

      Mineralize filter: Filters out only contaminants - important minerals remain in the water

      It is important to note that activated carbon filters cannot remove 100% of all contaminants, and effectiveness may vary depending on the specific contaminants in the water. In some cases, it may therefore be advisable to consider additional water treatment methods

      Are you satisfied with this article? Usefulness of the article: 1 / 0
      No
      How does the digital display on your water carafe work?

      The counter on your ionised water carafe indicates when the filter needs to be changed. Here is how it works:

      Start/reset button: When you insert a new filter or use the carafe for the first time, press the START button for 7-10 seconds. This resets the counter.

      The daily display (60 days): The display shows a number (in the picture: 60). This number indicates how many days are left until the next filter change. The counter automatically counts down from 60 to 0: These are not percentages, but actual days!

      The bar display (per cent): To the right of the display you will see four bars with a percentage scale (100%, 75%, 50%, 25%). These visually indicate the remaining filter service life in four stages. The fewer bars are filled, the closer the filter change is.

      When should you change the filter? When the counter reaches 0 and no more bars are filled, it is time for a new filter. Then press START again for 7-10 seconds to restart the counter.

      Are you satisfied with this article? Usefulness of the article: 0 / 0
      No
      Why doesn't my Valeacell carafe have an emblem/symbol at the bottom? My carafe has no emblem, no "flower of life" or aluminium plate at the bottom. Is this a cheap fake?

      No - that is intentional! Valeacell deliberately does NOT use optical illusions for ionisation.

      This is how real ionisation works:

      • Activated carbon filter (removes harmful substances)
      • Mineral spheres in the filter (produce alkaline water with pH 8.5-9.4)
      • No engraved "flower of life" necessary - this is pure optics without function

      The proof is scientific:

      • Buy a pH test strip (~€2 at the pharmacy)
      • Test the filtered water yourself
      • pH value 8.5-9.4 = real ionisation ✓

      Many cheap carafes have:

      • ✗ Engraved symbols (looks good, doesn't matter)
      • ✗ Aluminium plates (optical bluff)
      • ✗ "Energising" stickers (no function)

      Valeacell has:

      • ✓ Functional activated carbon filters
      • ✓ Mineral ionisation spheres
      • ✓ Measurable with pH test strips
      • ✓ No optical tricks

      Conclusion: No emblem = real quality, not optical bluff.

      Are you satisfied with this article? Usefulness of the article: 0 / 0
      No

    10 other products in the same category: